Hello folks,
Is it possible to just save the waveform data in the current displayed window? For example, I have a long continuous repeated signal. Once I zoomed in, I only have one of them displayed in the window. Can I just save the data for the displayed part instead of the whole sequence of signal? Thanks very much.
Toni
Save data for only displayed part?
-
- Advanced User
- Posts: 2856
- Joined: Tue May 31, 2011 3:43 pm
- Location: St. Neots, Cambridgeshire
Re: Save data for only displayed part?
Hi Toni,
The feature to save a zoomed region is not currently supported - there was an issue in the 6.7 Beta versions.
It may feature in a later release.
Regards,
The feature to save a zoomed region is not currently supported - there was an issue in the 6.7 Beta versions.
It may feature in a later release.
Regards,
Hitesh
Software Dev. Engineer
Software Dev. Engineer
Re: Save data for only displayed part?
Any news on this future request, or save data between rulers is also a good alternative if possible.
Regards,
Benno Geels
Regards,
Benno Geels
Re: Save data for only displayed part?
This is still on the list of features to add, there are quite a few, but we are working through them.
Martyn
Technical Support Manager
Technical Support Manager