Save data for only displayed part?

Forum for discussing PicoScope version 6 (non-automotive version)
Post Reply
Toni
Newbie
Posts: 0
Joined: Wed May 22, 2013 2:07 pm

Save data for only displayed part?

Post by Toni » Thu Aug 15, 2013 9:27 pm

Hello folks,

Is it possible to just save the waveform data in the current displayed window? For example, I have a long continuous repeated signal. Once I zoomed in, I only have one of them displayed in the window. Can I just save the data for the displayed part instead of the whole sequence of signal? Thanks very much.

Toni

Hitesh
Site Admin
Site Admin
Posts: 2793
Joined: Tue May 31, 2011 3:43 pm
Location: St. Neots, Cambridgeshire

Re: Save data for only displayed part?

Post by Hitesh » Mon Aug 19, 2013 2:09 pm

Hi Toni,

The feature to save a zoomed region is not currently supported - there was an issue in the 6.7 Beta versions.

It may feature in a later release.

Regards,
Hitesh

Technical Support Engineer

bennog
Advanced User
Advanced User
Posts: 106
Joined: Mon Nov 26, 2012 9:16 am
Location: Netherlands

Re: Save data for only displayed part?

Post by bennog » Tue Feb 04, 2014 10:32 am

Any news on this future request, or save data between rulers is also a good alternative if possible.

Regards,
Benno Geels

Martyn
Site Admin
Site Admin
Posts: 3226
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Re: Save data for only displayed part?

Post by Martyn » Wed Feb 05, 2014 7:10 am

This is still on the list of features to add, there are quite a few, but we are working through them.
Martyn
Technical Support Manager

Post Reply