Test and Measurement Forum

Relative times of triggers in rapid mode

Forum for discussing PicoScope version 6 (non-automotive version)

Relative times of triggers in rapid mode

Postby sboeser » Tue Jul 23, 2013 10:19 am

Hi,

I've been poking around in the forum a bit and it seems that it is just NOT possible to obtain the relative times in between the triggers in rapid mode (or even in bulk mode)? I have seen some mention of a "GetTickCount" function, but this is not documented in the API?

Are there plans to add this feature to the firmware in the future?

Thanks, Sebastian

PicoScope 6403
PS6000 Linux driver (development version)
sboeser
Newbie
 
Posts: 0
Joined: Tue Jul 23, 2013 10:09 am

Re: Relative times of triggers in rapid mode

Postby Martyn » Wed Jul 24, 2013 7:29 am

GetTickCount would be a windows/linux function within the application and nothing to do with the driver or scope. It would only give you an approximate time between successive triggers when using block mode of operation and repeating the runblock in a loop.

To time between successive captures in rapid block would require the addition of timing routines into the firmware of the device and unfortunately that is not on the current development pathway.
Martyn
Technical Specialist
Martyn
Site Admin
Site Admin
 
Posts: 2355
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots


Return to PicoScope 6 for Windows

Who is online

Users browsing this forum: No registered users and 0 guests