Test and Measurement Forum

Dead Channel A?

Post any questions you may have about our current range of oscilloscopes

Dead Channel A?

Postby gygill » Thu Jul 04, 2013 4:25 pm

I have a 3204 that I have been using for 6 years and love it. Recently I am unable to get anything on Channel A other than a slight glitch where there should be the start or end of a square wave. In addition the glitches are sometimes negative, which should be impossible. I have tried switching signals, probes, etc. The signals that should show on A are clearly showing on B. Can I assume that I have decimated my Channel A? Do you have any suggestions for further tests?
And assuming that I have indeed killed A, is there a repair capability in the US?
Thanks and regards,
Geoffrey Gill
Geoffrey Gill
gygill
Newbie
 
Posts: 0
Joined: Thu Feb 28, 2008 10:38 am

Re: Dead Channel A?

Postby Martyn » Fri Jul 05, 2013 6:04 am

As this is a repair request can you please direct your questions to support@picotech.com
Martyn
Technical Specialist
Martyn
Site Admin
Site Admin
 
Posts: 2355
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots


Return to USB PC Oscilloscopes

Who is online

Users browsing this forum: No registered users and 0 guests