Use Picoscope standalone

Post general discussions on using our drivers to write your own software here
Post Reply
siffer
Newbie
Posts: 0
Joined: Wed Jul 03, 2013 5:46 pm

Use Picoscope standalone

Post by siffer » Wed Jul 03, 2013 5:59 pm

Hello,
I am a new user of PicoScope 3206B. Is it possible to use it to collect data without connecting it to the computer and then save its buffer data into computer afterward? I want it to collect data for tens of minutes using low sampling rate, and then I can connect it to laptop and save the data in its buffer.
Thanks very much!

Hitesh
Site Admin
Site Admin
Posts: 2805
Joined: Tue May 31, 2011 3:43 pm
Location: St. Neots, Cambridgeshire

Re: Use Picoscope standalone

Post by Hitesh » Thu Jul 04, 2013 9:51 am

Hi siffer,

The PicoScope must be connected to the PC in order to collect data. There is a driver on the PC which sends instructions to the device in order to carry out data acquisition and control other features, plus the device requires USB power.

Best wishes,
Hitesh

Technical Support Engineer

siffer
Newbie
Posts: 0
Joined: Wed Jul 03, 2013 5:46 pm

Re: Use Picoscope standalone

Post by siffer » Thu Jul 04, 2013 12:25 pm

Ok, thanks very much.

Regards,

Post Reply