Test and Measurement Forum

PICO MI031 BNC Plug to Crocodile Clips

Post any questions you may have about our current range of oscilloscopes

PICO MI031 BNC Plug to Crocodile Clips

Postby Fivetide » Mon Jun 17, 2013 7:32 pm

Hi I have just a bought a 2nd hand Pico Scope 2205 off eBay , I want to learn electronics for Audio but don’t have that much money to spent on expensive equipment. The 2205 comes with the standard probe. What I ‘m asking is, could I use the PICO MI031 BNC Plug to Crocodile Clips to couple the AWG to a circuit?
Fivetide
Newbie
 
Posts: 0
Joined: Mon Jun 17, 2013 7:28 pm

Re: PICO MI031 BNC Plug to Crocodile Clips

Postby Hitesh » Tue Jun 18, 2013 3:52 pm

Hi Fivetide,

This should be possible. The max/min output of the AWG is +/-2V. The output current will be low as there is a 600Ohm impedance at the AWG output.

I hope this helps.
Hitesh

Technical Specialist
Pico Technology
Hitesh
Site Admin
Site Admin
 
Posts: 2058
Joined: Tue May 31, 2011 3:43 pm
Location: St. Neots, Cambridgeshire

Re: PICO MI031 BNC Plug to Crocodile Clips

Postby Fivetide » Tue Jun 18, 2013 8:00 pm

Would I be better using a probe ? Thanks for your reply .
Fivetide
Newbie
 
Posts: 0
Joined: Mon Jun 17, 2013 7:28 pm

Re: PICO MI031 BNC Plug to Crocodile Clips

Postby Hitesh » Wed Jun 19, 2013 10:41 am

You can if you use the x1 setting.
Hitesh

Technical Specialist
Pico Technology
Hitesh
Site Admin
Site Admin
 
Posts: 2058
Joined: Tue May 31, 2011 3:43 pm
Location: St. Neots, Cambridgeshire


Return to USB PC Oscilloscopes

Who is online

Users browsing this forum: No registered users and 0 guests