Test and Measurement Forum

Probe compensation

Having problems ? let us know the details here

Probe compensation

Postby liviod » Mon May 20, 2013 12:41 am

Hi, I'm after some assistance with adjusting the 10X compensation of my oscilloscope probes.
I have a 2207 scope with inbuilt AWG, when I set up a 1Khz square wave pattern @ 1volt and feed it back into channel A or B, I can’t seem to adjust the probe to a nice square wave.
If I set the probe to 1X it looks perfect.
I have tried 2 different probes and both have the same spikes shown - as per attached capture. The adjustment screw doesn’t seem to make any real difference to the pattern.
Not sure if I am doing something wrong here or if I have a problem with the scope.
Any sort of help would be appreciated.
Thanks,
Livio
Attachments
20130517-0001.psdata
Waveform capture
(220.85 KiB) Downloaded 110 times
liviod
Newbie
 
Posts: 0
Joined: Fri May 17, 2013 6:46 am

Re: Probe compensation

Postby Hitesh » Thu May 23, 2013 3:21 pm

Hi liviod,

Please refer to the article in the Application Notes section of our website:

http://www.picotech.com/applications/how-to-tune-x10-oscilloscope-probes.html

If you are still having a problem please e-mail support@picotech.com

Regards,
Hitesh

Technical Specialist
Pico Technology
Hitesh
Site Admin
Site Admin
 
Posts: 2058
Joined: Tue May 31, 2011 3:43 pm
Location: St. Neots, Cambridgeshire


Return to Getting Started

Who is online

Users browsing this forum: No registered users and 0 guests