How can I program the output signal

Forum for discussing PicoScope version 6 (non-automotive version)
Post Reply
yofine
Newbie
Posts: 0
Joined: Mon May 13, 2013 7:16 pm

How can I program the output signal

Post by yofine »

I have a picoscope2205A, and it is ready to take measurement. I want to use picoscope as a relay on a close loop system. Basically, I want to send output signal when the input is below a certain value. Any though on how I can achieve this?

Hitesh

Re: How can I program the output signal

Post by Hitesh »

Hi Yofine,

PicoScope 6.7 has a triggered signal generator feature that will allow you setup a trigger on a scope input and use that to trigger the output of the signal generator:



You should be able to setup a repeat trigger using the required voltage level and specifying a falling edge.

I hope this helps.

yofine
Newbie
Posts: 0
Joined: Mon May 13, 2013 7:16 pm

Re: How can I program the output signal

Post by yofine »

Thanks for your reply.

Post Reply