Test and Measurement Forum

How can I program the output signal

Forum for discussing PicoScope version 6 (non-automotive version)

How can I program the output signal

Postby yofine » Mon May 13, 2013 8:04 pm

I have a picoscope2205A, and it is ready to take measurement. I want to use picoscope as a relay on a close loop system. Basically, I want to send output signal when the input is below a certain value. Any though on how I can achieve this?
yofine
Newbie
 
Posts: 0
Joined: Mon May 13, 2013 7:16 pm

Re: How can I program the output signal

Postby Hitesh » Tue May 14, 2013 8:27 am

Hi Yofine,

PicoScope 6.7 has a triggered signal generator feature that will allow you setup a trigger on a scope input and use that to trigger the output of the signal generator:



You should be able to setup a repeat trigger using the required voltage level and specifying a falling edge.

I hope this helps.
Hitesh

Technical Specialist
Pico Technology
Hitesh
Site Admin
Site Admin
 
Posts: 2009
Joined: Tue May 31, 2011 3:43 pm
Location: St. Neots, Cambridgeshire

Re: How can I program the output signal

Postby yofine » Tue May 28, 2013 9:31 pm

Thanks for your reply.
yofine
Newbie
 
Posts: 0
Joined: Mon May 13, 2013 7:16 pm


Return to PicoScope 6 for Windows

Who is online

Users browsing this forum: No registered users and 0 guests