PicoScope 7 Software
Available on Windows, Mac and Linux
Custom Probe on Channel D causes Lockup
-
MeridenJohn
- Newbie
- Posts: 0
- Joined: Tue Mar 01, 2011 3:17 pm
Custom Probe on Channel D causes Lockup
I experienced a lockup when trying to select channel D as a trigger.
I have a 6402B and am using Picoscope 6.6.50.3
My setup was:
- Single trigger
- 20 ms time base
- Channels A, B and C are all voltage +/- 20 V , probes are internal X10
- Channel D is a custom probe, created when using a 3406B and an older version of Picoscope (don't recall which one)
Trigger was on Channel A, went to select channel D and the program locked up. I have not had time to try to repeat the issue.
Question is: should I recreate the custom probe under the current version of Picoscope? Is there a difference?
Thanks
MERJohn
I have a 6402B and am using Picoscope 6.6.50.3
My setup was:
- Single trigger
- 20 ms time base
- Channels A, B and C are all voltage +/- 20 V , probes are internal X10
- Channel D is a custom probe, created when using a 3406B and an older version of Picoscope (don't recall which one)
Trigger was on Channel A, went to select channel D and the program locked up. I have not had time to try to repeat the issue.
Question is: should I recreate the custom probe under the current version of Picoscope? Is there a difference?
Thanks
MERJohn
Re: Custom Probe on Channel D causes Lockup
The probe file should be fine to use for both scopes. The lockup when you enabled this channel may just be a coincidence, but if it is repeatable you could try recreating the probe.
Martyn
Technical Support Manager
Technical Support Manager