Test and Measurement Forum

Excel logging with ADC-11

Post general discussions on using our drivers to write your own software here

Excel logging with ADC-11

Postby RonyJ » Wed Nov 03, 2004 11:47 am


I'm using the Excel GetAdc11 macro which is supplied with the ADC11 unit. All works fine ... however I would like to be able to re-run the macro after it has been executed. If I do this at the moment it says Unable to open ADC (and I have to close Excel and re-open it before it works again).

I've tried to call adc11_close_unit subroutine... to close the active "connection" to the ADC11 device...but I couldn't seem to get it working.

Is there a way to automatically close this "connection" after the macro has run ... so that the macro can be re-run at a later time (without restarting the.xls file).


Postby markspencer » Fri Nov 05, 2004 9:40 am


I am sorry to hear that you are experiencing this problem.

I have replicated this problem as stated and passed it on to the development department, unfortunately there is no time scale I can give you for when the fix will be available.

Best regards,

Mark Spencer
User avatar
Site Admin
Site Admin
Posts: 598
Joined: Wed May 07, 2003 9:45 am

Postby RonyJ » Fri Nov 05, 2004 11:46 am

Thanks Mark,

I'm eargerly waiting a resonse !! :wink:

Return to General Software Discussions

Who is online

Users browsing this forum: No registered users and 2 guests