Test and Measurement Forum

pico5203 offset problem

Post any questions you may have about our current range of oscilloscopes

pico5203 offset problem

Postby richiechen » Mon Nov 05, 2012 1:05 pm

Hi

I am using pico 5203.
When the Channel 1 is used, there will always be an offset of 400mV. Even when I connect the ground probe with the signal probe, the offset still exists.

When channel 2 is used, it just works fine.

What happens? Could I calibrate it?

Thank you

Richie
richiechen
Newbie
 
Posts: 0
Joined: Mon Nov 05, 2012 12:59 pm

Re: pico5203 offset problem

Postby ziko » Mon Nov 05, 2012 5:12 pm

Hi Richie,

Have you tried this with nothing connected to the input?
Also what range is this offset on?
Is the offset the same on all ranges?

This looks most likely like a fault with the unit, please email support@picotech.com for further assistance.

Regards
Ziko

Technical Specialist
ziko
Zen Master
Zen Master
 
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots


Return to USB PC Oscilloscopes

Who is online

Users browsing this forum: No registered users and 0 guests