adc212 signal generator

Post any questions about our parallel port products
Post Reply
quarzorosso2

adc212 signal generator

Post by quarzorosso2 »

With sw rls 5.11.6 I check the box for enable the output, then I fix any frequency (1000 or 5000 or 100000 Hz) but at the output still to 5 Hz amplitude ca 3.5 Volt.

I boght the unit a weeck ago, remember that before the software upgrade the signal generator working well!

In your opinion the problem it's depending of the sw or the hw is broken?

Thanks a lot for who can help me.

quarzorosso2

sw release problem!?

Post by quarzorosso2 »

After that uninstall the last beta (?) release and reinstall the version 5.08.06, the signal generator work well!

That's an important information for sw developer, probably

User avatar
markspencer
Site Admin
Site Admin
Posts: 598
Joined: Wed May 07, 2003 9:45 am

Post by markspencer »

Hi,

Thank you for your information I have tested the latest version r5.11.6 with the different ADC-212 unit models available and did not find any problems. The frequency I specified in the signal generator dialog box was the frequency output by the unit.

The latest version available from our website is r5.11.6, is this the version that you had problems with.

Best regards,
Regards,

Mark Spencer

quarzorosso2

as up

Post by quarzorosso2 »

Thanks for your replay

now I'm in Spain for my job and with pico in my bag, when I can, when I don't need pico in the field I will retray to make upgrade.

Ciao

quarzorosso2

signal generator

Post by quarzorosso2 »

I'm to confirm that with Italian language installation still have problems.
With English language installation release 5.11.6 work well.
Another information for sw developer: the form of dialog box is different between English and Italian installation.

Please investigate about that.

Thanks in advances

Sarah

Post by Sarah »

Hi

Thank you for your post.

I will investigate this and pass my findings on to the software department.

Best Regards

Guest

Post by Guest »

Hi

do you have news?

Sarah

Post by Sarah »

Hi

Thank you for your post.

I have looked at this problem however have not yet been able to recreate it.

With your Italian version of software, is it all completely in Italian? Is it only with this version that it doesn't work?

Best Regards

Post Reply