Test and Measurement Forum

overflow flag not being raised

Post general discussions on using our drivers to write your own software here

overflow flag not being raised

Postby heng » Tue Aug 07, 2012 3:23 pm

I'm encountering a situation where apparently the overflow flag is not being raised desipite clipping occurring. Is this a problem that I might be expected to encounter?

My work around is to inspect the maximum absolute value of the returned array and change the voltage range if it's close to the limit, but this rather negates the point of the overflow flag.

Cheers,

Henry
heng
Newbie
 
Posts: 0
Joined: Mon Jun 11, 2012 7:08 pm

Re: overflow flag not being raised

Postby Martyn » Wed Aug 08, 2012 12:24 pm

Would it be possible to post your code here, or send it to support@picotech.com, so that we can take a look.
Martyn
Technical Specialist
Martyn
Site Admin
Site Admin
 
Posts: 2347
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots


Return to General Software Discussions

Who is online

Users browsing this forum: No registered users and 0 guests