4424 software installation

Forum for discussing PicoScope version 6 (non-automotive version)
Post Reply
elirub
Newbie
Posts: 0
Joined: Fri Jul 20, 2012 1:32 pm

4424 software installation

Post by elirub »

Trying to install software for 4424.
Installer asks for "Device". In drop-down list there is no 4000 series.
Checked for larest software version, however, the report is that the version on the CD is the latest.
What do I put as "Device" to continue installation?

Martyn
Site Admin
Site Admin
Posts: 4491
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Re: 4424 software installation

Post by Martyn »

That sounds like you are trying to install Picolog software.

The 4424 only works with PicoScope6 software so if you install and run this it should find the scope.
Martyn
Technical Support Manager

elirub
Newbie
Posts: 0
Joined: Fri Jul 20, 2012 1:32 pm

Re: 4424 software installation

Post by elirub »

Thanks Martyn
The scope works now.
Would appreciate to be able to use it also as a 4 channal data logger.
Shouldn't I be able to use the PicoLog?

Martyn
Site Admin
Site Admin
Posts: 4491
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Re: 4424 software installation

Post by Martyn »

Our newer scopes are not supported under Picolog.

However using the alarms features and saving data when buffers are full it is possible to configure PicoScope 6 to log data over extended periods of time. Please check out the videos at http://www.picoscope.tv/general/using-alarms.html
Martyn
Technical Support Manager

Post Reply