Using the Digital output on ADC11

Post any questions about our parallel port products
Post Reply
Phillip Green

Using the Digital output on ADC11

Post by Phillip Green » Wed Nov 06, 2002 12:49 pm

How do you use the digital output on the ADC11, I need this to start my experiment, before I can begin data logging. In the ADC11 manual a second digital input is mentioned, but I can't find it.

James

ADC11 digital output

Post by James » Wed Nov 06, 2002 3:56 pm

If you need to use the digital output, you will need to write your own software using our examples, as PicoLog and PicoScope do not control it.
These packages just set it to be left on.

The functions you need are:

adc11_set_do and adc11_set_do2 contained in the adc11.dll file.

The second output is only available if you specifically ask for it when ordering your ADC11 from us.

Post Reply