Simultaneous connect to Picoscope 3204A via PS3000a.dll

Post general discussions on using our drivers to write your own software here
Post Reply
bikertt
Newbie
Posts: 0
Joined: Tue Jun 05, 2012 7:18 pm

Simultaneous connect to Picoscope 3204A via PS3000a.dll

Post by bikertt »

Will the configuration be the same as configured with the PicoScope 6 - Software when I read the values with my software?

Thank you very much, Michael
-->
Hello,

I figured out that it is not possible to connect the Picoscope 3204A to the PicoScope 6 -Software and to my own programmed Application at the same time. Is it really not possible or is it a failure by myself?

I use the API ps3000aOpenUnit of PS3000a.dll.

What I want to do ist the following:

Configure the PicoScope with the PicoScope 6 - Software and then read out the Measurements in my own Application.

It would be nice to have both Applications conneted at the same time so I can see the signal in the PicoScope 6 Software and the read values in my Software.

If it is not possible to connect simulaneously is this possible:
- Configure the PicoScope with the PicoScope 6 - Software
- Close the PicoScope 6 - Software
- Connect to PicoScope with my Application and read out the values. --> Will the configuration be the same as configured with the PicoScope 6 - Software when I read the values with my software?

Thank you very much, Michael