Post general discussions on using our drivers to write your own software here
When I install the drivers manually and then insert the usb from a ADC-24 it says device not recognised. Only way is to install the PicoLog software first. Any solution or am I doing something wrong?
- Posts: 0
- Joined: Thu Jun 07, 2012 2:14 pm
Which operating system are you installing the driver on?
Try copying the contents of the picopp folder into the winusb/x86 directory for a 32-bit system or winusb/amd64 directory for a 64-bit system and then run the DPInst executable.
Hope this helps,
- Site Admin
- Posts: 2196
- Joined: Tue May 31, 2011 3:43 pm
- Location: St. Neots, Cambridgeshire
Return to General Software Discussions
Who is online
Users browsing this forum: No registered users and 0 guests