Test and Measurement Forum

problem getting software to work

Post any questions you may have about our current range of oscilloscopes

problem getting software to work

Postby dangraf » Thu May 24, 2012 7:14 am

Hello!
This is probably stupid questions but i try anyway.
I just installed my first picosocpe 4424 together with version 6.6.23.2 of the picosope 6 software.
When i start the software i'm only allowd to select channel A. But the scope has 4 channels.

Another thing is that i wanted to install picolog but then installing I need to tell which series of the scope I got. There is no selection for the 4000 series, which one should I select?

Best regards
/Daniel
dangraf
Newbie
 
Posts: 0
Joined: Thu May 24, 2012 7:10 am

Re: problem getting software to work

Postby Martyn » Thu May 24, 2012 7:40 am

By default only Channel A is enabled, to turn on the others use the drop down box that says Off and select an appropriate range, or Auto

Picolog does not support our newer scopes including the 4424, you can achieve logging by carefully setting up the PicoScope software and using the Alarms feature to auto save data files.
Martyn
Technical Specialist
Martyn
Site Admin
Site Admin
 
Posts: 2350
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots


Return to USB PC Oscilloscopes

Who is online

Users browsing this forum: No registered users and 1 guest