Test and Measurement Forum

Pico Log 1216 & Circuit Board

Having problems ? let us know the details here

Pico Log 1216 & Circuit Board

Postby James.baskerville » Tue May 22, 2012 1:33 pm

I`m currently developing a machine where a blade passes through two light beam sensors which are attached to two amplifiers. I am hoping to pick up a signal using the picoscope so that I can accurately measure the speed of the blade as it passes through the two beams. The voltage is 24V dc, looking through your manual I can reduce this to under 2.5V using the potential divider Vadc = (Vin x R2) / (R1+ R2). Am I correct by using (24 x 1000) / (10000 + 1000)= 2.18V dc.?
According to the diagram in the manual would I take +24V to connection C1 & 0V to ground connection?
Posts: 0
Joined: Tue May 22, 2012 1:19 pm

Re: Pico Log 1216 & Circuit Board

Postby Martyn » Thu May 24, 2012 10:44 am

That is correct.
Technical Support Manager
Site Admin
Site Admin
Posts: 3099
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Return to Getting Started

Who is online

Users browsing this forum: No registered users and 0 guests