Success at setting trigger in series 3000A/B?

Post general discussions on using our drivers to write your own software here
Post Reply
fungus421
Newbie
Posts: 0
Joined: Thu Mar 01, 2012 3:24 pm

Success at setting trigger in series 3000A/B?

Post by fungus421 »

Good afternoon all,

I'm having difficulties setting the trigger for a 3206B, the status are all 0 (which mean everything's ok :!: ) but I still can't seem to have the response I'm looking for.

I tried also the vi in the SDK and if i set the timeout parameter to 0 it doesn't respond at all. I am positive I am sending a signal, since it works just perfect from PicoScope 6.

Does anyone has any advice? I'm not using the SimpleTrigger function but i'm setting the conditions, properties and directions myself.

Thanks in advance :) ,

Alejandra.

Martyn
Site Admin
Site Admin
Posts: 4491
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Re: Success at setting trigger in series 3000A/B?

Post by Martyn »

Are the trigger threshold values you are using correct ?
Martyn
Technical Support Manager

Post Reply