Test and Measurement Forum

Success at setting trigger in series 3000A/B?

Post general discussions on using our drivers to write your own software here

Success at setting trigger in series 3000A/B?

Postby fungus421 » Wed Mar 07, 2012 3:55 pm

Good afternoon all,

I'm having difficulties setting the trigger for a 3206B, the status are all 0 (which mean everything's ok :!: ) but I still can't seem to have the response I'm looking for.

I tried also the vi in the SDK and if i set the timeout parameter to 0 it doesn't respond at all. I am positive I am sending a signal, since it works just perfect from PicoScope 6.

Does anyone has any advice? I'm not using the SimpleTrigger function but i'm setting the conditions, properties and directions myself.

Thanks in advance :) ,

Alejandra.
fungus421
Newbie
 
Posts: 0
Joined: Thu Mar 01, 2012 3:24 pm

Re: Success at setting trigger in series 3000A/B?

Postby Martyn » Mon Mar 12, 2012 3:31 pm

Are the trigger threshold values you are using correct ?
Martyn
Technical Specialist
Martyn
Site Admin
Site Admin
 
Posts: 2348
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots


Return to General Software Discussions

Who is online

Users browsing this forum: No registered users and 0 guests