Frequency response in Labview

Guest · Post by **Guest** » Fri Aug 27, 2004 3:50 am

G'day Folks

I am currently writing some code in Labview 7.0 using an ADC-200 to measure the frequency responses of basic filters using a sineswept input.

I have tried connecting some Labview modules (FRF, CROSS etc) to the output of the ADC200.vi but I don't seem to be getting a proper response either with the magnitude or phase.

I can measure the signal and calculate the FFT but the responses are not correct.

I was just wondering if anybody has done something similar or knows of similar code using Labview and the ADC200.

cheers

/Vince

markspencer · Post by **markspencer** » Fri Aug 27, 2004 12:09 pm

Hi,

I am sorry to hear that you are experienging problems with Labview and ADC-200, there are very simple examples availalbe sowing how the routins should be used, but may not go far enough on the labview side for you. The example scan be downloaded by following the appropriate button at the bottom of the page.

Perhaps someone else on the forum will be able to assist with the Labview code.

Best regards,

deeps_k123 · Post by **deeps_k123** » Mon Mar 28, 2005 6:50 pm

Helloooo...

Iam also having the same problems with the code.Kindly request you to give me the code if you got good resultys.Iam in very much need of it.

Regards,
deepu