Multiple Cursors

Forum for discussing PicoScope version 6 (non-automotive version)
Post Reply
Gucci
Newbie
Posts: 0
Joined: Fri Nov 18, 2011 2:14 pm

Multiple Cursors

Post by Gucci »

Please can you allow more than 2 cursors (on all axes).

It would be really useful when doing some measurements if this was possible. If you don't want this to be a standard option, perhaps it could be a configurable option. I can't see any reason to limit the number of cursors.

Also, you might want to consider adding cursors to a menu item, as I struggled to find them to start with, until I noticed the tiny little squares in the corners, after resorting to reading the manual!

Thanks.

Martyn
Site Admin
Site Admin
Posts: 4491
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Re: Multiple Cursors

Post by Martyn »

I have passed your comments onto the development team for consideration in a future release.

Thank you for your feedback.
Martyn
Technical Support Manager

Post Reply