Conformal Coating

Post any questions you may have about our current range of oscilloscopes
Post Reply
BSI
Newbie
Posts: 0
Joined: Wed May 12, 2010 3:15 pm
Location: Canada

Conformal Coating

Post by BSI » Thu Nov 24, 2011 6:44 pm

Hi,
I was wondering if Pico digitizer boards could be ordered with conformal coating please?
Thx.
Laurent

Hitesh
Site Admin
Site Admin
Posts: 2794
Joined: Tue May 31, 2011 3:43 pm
Location: St. Neots, Cambridgeshire

Re: Conformal Coating

Post by Hitesh » Fri Nov 25, 2011 9:51 am

Hi Laurent,

We do not provide conformal coating, but you could either undertake this yourself or have this done elsewhere. Please note that if a fault deveoloped with the unit, it would make it harder to repair, although we would endeavour to do what we can.

I hope this helps.
Hitesh

Technical Support Engineer

BSI
Newbie
Posts: 0
Joined: Wed May 12, 2010 3:15 pm
Location: Canada

Re: Conformal Coating

Post by BSI » Sat Nov 26, 2011 1:52 am

Would you have any suggestion as which coating to use . Is there any concern with heat dissipation?
Thx
L.

Hitesh
Site Admin
Site Admin
Posts: 2794
Joined: Tue May 31, 2011 3:43 pm
Location: St. Neots, Cambridgeshire

Re: Conformal Coating

Post by Hitesh » Mon Nov 28, 2011 2:59 pm

Hi Laurent,

Could you please clarify which PicoScope model you are interested in - is it the 6407? If so, it has an onboard fan as it requires an additional power supply.

If you have any further information about the environment (i.e. temperature, environment) and how you intend to use the device, that would be helpful.

Regards,
Hitesh

Technical Support Engineer

BSI
Newbie
Posts: 0
Joined: Wed May 12, 2010 3:15 pm
Location: Canada

Re: Conformal Coating

Post by BSI » Tue Mar 27, 2012 6:35 pm

Temperature range: -20/-10oC to + 40oC. I am mainly interested for the cold side of the range.
Elevation: typically 2500m, but could be 5000m / 6000m.
The board remains protected inside its case, and is sitting inside en enclosed enclosure
Model: 4227.

What would you recommend for conformal coating? Are there some components that should remain free of conformal coating?

Thx

Laurent

Hitesh
Site Admin
Site Admin
Posts: 2794
Joined: Tue May 31, 2011 3:43 pm
Location: St. Neots, Cambridgeshire

Re: Conformal Coating

Post by Hitesh » Wed Mar 28, 2012 10:32 am

This post has been answered via the Helpdesk.
Hitesh

Technical Support Engineer

Post Reply