PicoLog not recording correct data

Forum for discussing PicoLog
Post Reply
Ian11
Newbie
Posts: 0
Joined: Tue Oct 11, 2011 1:13 pm

PicoLog not recording correct data

Post by Ian11 »

Hi there

I'm using a Pico ADC-11 logger to record a number of channels from a dynamometer, such as load and position. As the motor rotates at a maximum speed of 197rpm, I'm looking to record data over just one revolution, which takes around 0.3 seconds. Using Real Time Continuous recording I get accurate results, but at a sampling rate that is too slow for the application. In order to gain a greater number of results I have tried using Fast Block recording, but whatever I set the recording time or number of samples to, I get what appear to be corrupt results where the time and voltages go way out of range. Is this a common problem, or do I have some settings wrong?

Please find an example of the data attached, the highlighted section is the correct data, and the data below it is causing the problem.

Regards

Ian
Attachments
Problem Example.doc
(137.5 KiB) Downloaded 590 times

Post Reply