I understand that, but I do not know the specs of the device in question with regards to turning on and off a channel. So this is the part I need your help for. Essentially what is the # cycles the ON OFF relay (if it is a relay) in the 4227 can take? There should be a spec for this.

Thx
Laurent

Ok, thx Hitesh.
Laurent.

Temperature range: -20/-10oC to + 40oC. I am mainly interested for the cold side of the range. Elevation: typically 2500m, but could be 5000m / 6000m. The board remains protected inside its case, and is sitting inside en enclosed enclosure Model: 4227. What would you recommend for conformal coating?...

I am using a Pico 4227 for an application that requires the device to be operating hours at a time. The general procedure being implemented is a Rapid Block Mode acquisition at 250MS/s (1 ch) or 125MS/s ( 2 ch) and filling up the buffer with a few thousands points at most, repeatedly ~ 500 times eve...

Is there any plan to have ETS working for Rapid Block Mode ? At the moment it is supposed to only work with Rapid Block.
Thx
Laurent

Hi, I attached an example based on the available lib from pico trying to use the Pico4000AdvancedTriggerSEttings.vi from the sdk ver r.10.1.0.17. My main objective is to get a logical trigger "A or B" working. To test the code, I use two 0-5 V square waves, one on channel A of a pico 4227, one on ch...

Thx Hitesh.
I am using RapidBlock Mode, not streaming.

Yes, this is the same 4227 I was referring to with regards to conformal coating.
Laurent

Would you have any suggestion as which coating to use . Is there any concern with heat dissipation?
Thx
L.

Hi,
I was wondering if Pico digitizer boards could be ordered with conformal coating please?
Thx.
Laurent

Hi Hitesh, Can you clarify "the Number of the Sample" from your post please? Essentially I have 2 inputs connected to the digitizer. The signal comes alternatively from either A or B, and I want to make sure that when a trigger occurs from signal A (B) , it is actually the case so that I can pull th...

With a 4227 set on logical triggering "Trigger on Input A or Input B" , does the driver return which input has received the trigger? I need to know which input was triggered to process my data accordingly. Processing will depend whether the signal was coming in from Input A or Input B.
Thx.
Laurent

Yes it works well. I now have tried and all is fine.
L.

Hi, I am working with a 4227, and LabVIEW performing Rapid Block Acquisition. I need to acquire a predefined number of captures, let's say 100, and average the resulting 100 segments. However, sometimes the incoming signal may change so that a trigger is not detected leading the digitizer to perform...

Thx Ziko . I had missed it on the specs. So presumably it will detect a TTL level change.
L.

What type of trigger can the EXT input work with on a 4227 ? TTL (0-5V) digitial inputs? analog?
Thx.
Laurent