Hello Lindi,

Our Linux expert advises that the problem does not lie in our driver, and suggests that you may wish to try updating your gcc and glib.

Regards
John

Hello Prakti,

Please use the latest release R6.0.16 which should solve that behaviour.

John

Hello Simon,

You could do that or, you could use the resistance input of DrDAQ with your own light sensor.

Please refer to the user guide for details (http://www.picotech.com/document/pdf/drdaq044.pdf).

John

Hello Ferhan,

Please feel free to share your solutions using Pico products on this forum.

John

Hello Dave,

PS6 is not an evolution of PS5, however, the nearest equivalent to 'options' in PS5 is Tools>Preferences in PS6.

Regards
John

Hello guest,

A sampling oscilloscope relies upon the waveform being repetitive as in ETS.

Regards
John

Martin,

Could you attach your .pls file.

John

Hello Aaron,

You need to install the converter according to the manufacturer instructions and then find out which COM port has been assigned by your operating system. You should then use that COM port when configuring EnviroMon.

Regards
John

Did you reset and re-configure after the logload? If not, please try that.

Regards
John

Hello guest,

The total buffer memory is 512k if a single channel is used or, 256k for two channels or, 128k for three or four channels.

Regards
John

Hello Simon,

It is unclear what you mean by:

'... can I disconnect the light gate from the board and stick it on the end of a sensor inside the moment ...'?

Regards
John

Martin,

Pins 15 to 25 are open ciruit within the unit but, connected to ground if you use the ADC-11 Terminal Board.

Regards
John

Sandy, I do not know what is wrong with your PC but, you say that the message DEMO appears. If DEMO relates to Pico software, then you need to do as I suggested before and uninstall/remove all Pico software and files, and start again. You should enable hidden files to be viewed when searching for an...

Hugo, Please use the Pico utility to uninstall R5.16.2 and then install R5.20.1 ( http://www.picotech.com/software.html ). Ensure that you tick the box to 'support other devices' after you select the device type during installation. Do not connect the ADC-11 during software installation and, before ...

Hello Hugo,

Which version of PicoLog are you using and on what specification PC and operating system?

Do you have or, have you had any other Pico software installed on the PC?

Regards
John