Hi,

Try using the example C application, it is designed to get you started with these sort of applications. You could also try downloading the latest software to ensure that you have USB support installed.

Regards,
Matt.

Hi Graham,

The equation shouldn't be a problem for PicoLog once you've converted it to our notation (as detailed in our help files).

Best Regards,

Hello, This isn't a bug, it is a limit we have imposed on the spreadsheet mode, we are looking to extend this in a future software version, but unfortunately this won't be for some time due to other development commitments. There is a simple workaround: use File | Save as... and save as file type .t...

Hi Roger, 1. There aren't any specified limits for the noise floor, but the unit's dynamic range approaches 20log(resolution). ie 72dB range for a 12bit ADC-212. 2. Yes, just divide the total frequency range selected by the resolution you have selected from Settings | Options . This will give you th...

Hi Oleg, The ADC-2xx series can perform up to approx. 200 downloads per second in ' rapid_mode '. You can find details on how to set this up in the ADC-200 product manual . I can't give any firm answers on specific cases, as it can vary from PC to PC, but the download rate for the parallel port is u...

Yes, no problem ... if you know the equation!

Regards,

Hi Graham, If you are talking, 40 to 150degC then our humidity sensor won't be able to cope with this either. I can't remember the equations for relative humidity now (its been a while :roll:). The correct terminology is Wet Bulb Temperature , try typing it into a search engine; I'm sure there will ...

Hi, I tried the following File which is very similar to yours but more suitable for my equipment: [Scale50] Resistor=2.2 LongName=Bubble Period ShortName=BperS Units=secs MinValue=0 MaxValue=40 OutOfRange=0 Places=0 Method=0 Fast=No NoOfPoints=2 Raw1=0 Scaled1=0 Raw2=2.5 Scaled2=40 This worked fine ...

Yes thats fine.

Our scopes are £15 excluding Tax & delivery.

Regards,

Hi again Steve, I'm afraid you won't be able to do the temperature compensation like the built in pH channel, because this all goes on inside the software. The only suggestion I could make is to use Settings | Calculated parameters to perform the calculations in real time (the help file details how ...

Hi John,

The tc08.tar archive is our only example program for Linux. But we do have Delphi example files as well.
These are available through the downloads page when you install the drivers and manuals.

I have emailed you a copy of the full linux driver, as this may help you.

Kind Regards,

Hello Nazree,

You will need a scope probe, you can ring us up to order one of these. You can then use this to test different points on the board.

Best Regards,

Hi Steve, Unfortunately, I can't release circuit diagrams (for obvious reasons). We're selling a packaged product, and a lot of development time has gone into them so I can't send out operational information on the software / hardware in a lot of cases. The help files do contain a wealth of informat...

Hi, I'm not sure what you mean by receiver board, what does it recieve? If you don't put any power into a board, then you are unlikely to be able to measure any power coming out of the board. PicoScope is Oscilloscope software which takes data in chucks, usually synchronised by a trigger. PicoLog is...

Hi there, I will briefly explain each point. 8 bits resolution 2^8 = 256 measurable increments over the voltage range BNC channel The input connector socket type ±5V Voltage Ranges The input voltage range the unit can measure, -5V to 5V. 30V Over Voltage The maximum voltage that the unit can be expo...