Hi the plw data file that or the pls settings file.

Regards

Hi the 10 measurements in a second is possible if you are using it as a voltage input and not a thermocouple input. In terms of your configuration could you send me you data or settings file?

Regards

Hi the Picolog 1000 replaces the USB ADC11:

http://www.picotech.com/multi-channel-daq.html

Unfortunately we do not do the terminal board for the ADC 11 anymore.

Regards

Hi,

Just to confirm the 4262 and none of our scopes are optically isolated.

Regards

Hi James, I assume you are buying this second hand or old stock as we do not make these anymore. Are you also getting the terminal board with this as it is very useful to have? In any case you will need to create a potential divider circuit do drop the incoming voltage into the logger for more infor...

Hi, The USB TC-08 has a single ADC with a conversion time of 100ms, to take the measurements for one channel it also has to read the cold junction, so for one channel the fastest rate you will have is 200ms , for 2 channels it will be 300ms. There may also be some small overhead time. How many chann...

Hi unfortunately the 3425 does not have logic trigger it is one of our first scopes that included advanced trigger on it.

Hi Phil,

We have extended the time bases for PicoScope 6 for longer captures, which is good for short term tests. Unfortunately there are not plans to add the 4000 or any of our news scopes to PicoLog.

I will forward your comments to the relevant people.
Regards

Hi thank you for your post, I realise you sent an email on support@picotech.com I will carry on answering this on the helpdesk.


Regards

Hi Heng, Please find response below: " Does that mean that if the ultimate pulse length is longer than 100ns, that fact doesn't influence whether the trigger fires. Yes. In the example we have defined (using the trigger circuit) a "pulse" as being the time between an edge on ChA and a subsequent edg...

Hi I have deleted the response I sent earlier and used one of our engineers responses as it straight from the source so let me know if you have any further questions: " Not sure what product, so I'll refer to PS3000A. 1. You cannot create an impossible trigger because separate conditions are OR-ed t...

Hi Glubb, Some of the higher end products will have better signal generators but none of them will be as good as a dedicated signal generator. The harmonics you see are because of the fact that the scope is an 8bits that when sold was less than £200. The other thing I notice is that you are using +/...

Hi Glubb, I will answer the first forum post you sent on Sunday first : Try using a repeat trigger instead of an auto trigger as you may be getting skewed results due to hysteresis, particularly on the larger voltage ranges, +/-20V. In terms of your two signals try using the same voltage range, it l...

Hi Ken,

The low pass filtering option is not available on all our products, specifically the lower memory devices. You can however have a similar effect by using resolution enhancement. This is also available from the same area.

Hope this helps.

HI thank you for your post. I am not sure I fully understand your post, what do you mean by site? The second question, if you are asking if you can print different views or buffers with one print statement as separate sheets then this is not possible. In terms of your last signal, I assume you are u...