Hi,

Unfortunately our LabView expert (Mark) is on holidays, he will be back on the 2nd of January. All I can suggest is that you have a look at the C examples to see how the 'run ADC100' and 'ready ADC100' routines are used.

Best regards,

Ric

Hi, Thank you for your enquiry. We don't offically support MatLab, we don't have any examples so I'm not sure how easily you could transfer data. With PicoLog and PicoScope you can export data by saving it as a CSV file or by using the Dynamic Data Exchange (DDE). For any other methods of transferin...

Hi,

To be able to help any further we need to know if you get the same results using PicoLog.

Best Regards,

Ric

Hi,

We are investingating your query and will shortly get back to you.

Best Regards,

Ric

Hi Jim,

Thank you for your enquiry. Unfortunately our software will not be able to convert the audio signal to a .wav file. I'm not even sure if this is at all possible. Perhaps someone else in the forum has some experience with this?

Best Regards,

Ric

Hi,

Thank you for your enquiry. Calibration of the FirstLook sensor is not required.

The high CPU usage you are experiencing is normal, PicoScope was designed for specific reasons to use as much of the available CPU resources as possible. The next release of PicoScope will not use as much CPU resources while it is not sampling. Unfortunately I cannot give you a specific date as to w...

Hi, Unfortunately we don't have any sensors for air velocity, you may find something suitable in the RS Catalogue. For temperature and RH I would recommend the RH-02 Humidity and Temperature Converter, you will find details and specifications on our website, http://www.picotech.com/humidity.html Bes...

Sounds very odd. Not having the ADC-100 connected will give you an error message indicating so, but the program should still run (obviously you won't be able to take readings). The other thing to check, is that you make sure you have rebooted the laptop after installing the software. This has to be ...

Hi,

Do you have Admin privileges on your laptop?

Best regards,

Ric

Sounds like there is something wrong with your PC. Have you tried reinstalling the software? Is there any chance your parallel port settings in the BIOS could have been changed? The I/O address should be 378 and the IRQ 7. The correct parallel port mode should be either SPP, Normal, Output only or U...