Search found 157 matches

by alan
Fri Dec 08, 2006 10:52 am
Forum: PicoScope 5
Topic: ChA+ChB ; ChA*ChB ; Invert ChA ...
Replies: 4
Views: 4784

Hi,

You can easily invert a channel in PicoScope by setting a custom range. For example if you select

1000 -1000
0 0
-1000 1000

As the scaling then you have a 1V range that is inverted.

Regards
Alan
by alan
Tue Nov 28, 2006 7:22 am
Forum:
Topic: PicoScope 5000
Replies: 3
Views: 4541

Re: PicoScope 5000

Hello. I have a few questions about the PicoScope 5000 series oscilloscope. A. What is the max input voltage? Is it 5V? How can one measure HV signals? Is there any way to extend that to ~20kV RMS? Does this scope support x1000 probes? The maximum input range using a x1 probe is 20V. The software s...
by alan
Sat Nov 04, 2006 12:05 pm
Forum: Pre-Sales Advice
Topic: engine valve leak detection sensor
Replies: 1
Views: 2918

Hi,

I would suggest you look at the firstlook sensor which has been successfully used to detect leaking valves.

http://www.picotech.com/auto/engine_dia ... ensor.html

Regards
Alan
by alan
Thu Oct 19, 2006 7:34 pm
Forum: Pre-Sales Advice
Topic: how do reinstall my PICO software? My PC re-formatted!
Replies: 1
Views: 2841

Hi,

Are you sure you are talking about a Pico Technology product, our products are external oscilloscopes / data loggers that plug into the USB, serial or parallel port.

Regards
Alan
by alan
Fri Sep 15, 2006 8:01 pm
Forum: Getting Started
Topic: RVC/LIN
Replies: 1
Views: 3017

Hi,

There is a bit on the web site about the LIN bus
http://www.picotech.com/auto/waveforms/lin_bus.html

If you have the automotive software, the LIN bus topic is under CAN bus on the automotive drop down menu.

Best Regards
Alan
by alan
Fri Sep 15, 2006 4:46 pm
Forum:
Topic: 3206 and 200MHz frequency
Replies: 2
Views: 4195

Hi, The single shot sampling rate of the 3206 is 200MSPS so with a 75MHz sinewave you have about 3 samples per waveform. To view higher frequency signals I suggest you use ETS sampling which boosts the sampling rate to GSPS but only works for repetitive signals (ie the sort of fast waveforms that co...
by alan
Wed Jun 14, 2006 6:35 pm
Forum: PicoScope 5
Topic: Second hand Picoscope supplied without a Parallel Cable
Replies: 2
Views: 3290

Hi, The parallel cable is a D25 male to female. The pins are wired 1-1, 2-2, 3-3 etc. All pins are connected. You can get the latest software from the web & hopefully you have the power supply - if not it needs between about 9V and 24V and the centre pin of the power connector is positive. Regards A...