Search found 7 matches

by jansonr
Fri May 12, 2006 10:26 am
Forum: MATLAB
Topic: MATLAB and usb tc-08
Replies: 13
Views: 31265

matlab

I used the support for .dlls in MatLab 7. To be honest I'm not much of a programmer and have very limited knowledge of C, so found it tough trying to work out what was going on. Also when I was doing the work the dll support in MatLab was almost non-existant as it's a new feature. I'll have a dig ro...
by jansonr
Thu May 11, 2006 2:13 pm
Forum: MATLAB
Topic: MATLAB and usb tc-08
Replies: 13
Views: 31265

Hi, I could get the tc-08 to do everything but stream the data, but every time I tried to read from it MatLab would crash. I haven't really used the system since as I've been working on other things however, so haven't tried much more. If you get anywhere with it I would like to see how you did it t...
by jansonr
Mon Oct 03, 2005 2:33 pm
Forum: MATLAB
Topic: MATLAB and usb tc-08
Replies: 13
Views: 31265

drivers

I heard on the forum that you have drivers/matlab examples for at least one of your other products (although I forget which one).

Could you send me these files so I could get a better picture about how the code should look?

Thanks,

Rob
by jansonr
Wed Sep 28, 2005 2:53 pm
Forum: MATLAB
Topic: MATLAB and usb tc-08
Replies: 13
Views: 31265

MATLAB and usb tc-08

I know you don't officially support MatLab, but I'm trying to write code to control the USB tc-08 in streaming mode but cannot get it to work properly. Do you have ANY examples you could show me that might give me a hint (or does anybody have any MatLab code that might help me?) Also could you give ...
by jansonr
Wed Aug 31, 2005 11:47 am
Forum: Pre-Sales Advice
Topic: ADC-100 scope
Replies: 1
Views: 4378

ADC-100 scope

I am looking to measure a signal from two load cells at 100Hz or faster. The signals are only about 1mV peak. Is the ADC-100 acurate enough to measure these signals or would they need to be amplified? If they do need amplification do you sell the required equipment? What maximum sampling rate would ...
by jansonr
Fri Aug 12, 2005 10:15 am
Forum:
Topic: usb tc-08 accuracy
Replies: 1
Views: 5126

usb tc-08 accuracy

How accurate is the usb tc-08 with very low signals? I see that the accuracy is listed at 20bit which (I believe) should give it good resolution over the +-70mV range it operates over. However I want to measure a load cell output signal of about 2mV maximum amplitude. Is this possible, or would I ne...
by jansonr
Fri Nov 26, 2004 4:37 pm
Forum: Pre-Sales Advice
Topic: usb tc-08
Replies: 1
Views: 5624

usb tc-08

I have been using a serial tc-08 that I borrowed from a friend to sample a 0-50mV signal. I now need to return the converter, and would like some advice as to a replacement. If possible, I would like a low cost sampler, capable of measuring multiple channels (at least 3) for a range of 0-50mV. I do ...