I have provide a .psdata file showing the 1-wire bus decoding. Also did a JPG of the scope screen capture. You can see that the 1st "command code" being decoded is 0xAA, where it should be 0x55 (Match ROM command). I am not sure what is wrong with my setup?

Looking at the actual waveform (with a different bench scope), the waveform looks correct (not inverted). If I try the "inverted" selection on the 1-Wire-bus decoder settings panel, it then dopes not decode anything. it just seems as if the picoscope software is decoding the waveform backwards (MSB ...

I have board using an Atmel 2651 MCU using a port pin that is driving a 1 wire bus to 3 DS2433 eeprom devices. The bus has a 4k7 pull-up resistor to VCC (+5v). I am using a 2205A Pico scope. It is working as expected. When using the Picoscope6 software (Windows) it appears as if the software is deco...