Hi, I have had some missing data in certain sections of my logging. Some sensors have not recorded a value at certain time points, other times all sensors have a blank at a time point. Additionally, it looks likes one of my sensors was reading as 0 pressure for around 4 hours. Not sure if this is ha...

figured it out, the input is in V not mV! doh!

Hi All, I have obtained calibration slope of pressure sensors with a calibrated pressure input and have recorded the voltage against this to plot a chart, obtain the Y equation with a view to input this into the software to convert V to pressure. When i apply the equation e.g. - y(pressure) = -0.144...

Gerry wrote: ↑

Fri Jan 15, 2021 2:45 pm

Hi Woster,

Could you post your data file.

Regards,

Gerry

Hi Gerry,

Can i send the data over email?

Hi Gerry,

Thanks for the reply.
I am currently unable to at the moment as the laptop has both USB taken. Will send over asap.

Thanks

Good afternoon, I'm looking for some advice with PICOLog and digital pressure sensors. I have a 1216 with 8 channels monitoring pressure. I want the data time stamped and recording interval of 30 minutes. i have the sensors reading every 30 seconds, for the graph, but the table and datalogging is 30...

Hi Wooster, As I mentioned, just getting some shielded, single core cable, should solve the problem. However, just so that we are on the same page, could you post Picolog data files showing the 'bouncing' you mentioned, at different sample rates, and also post an image (or images) of your setup. Re...

did you manage to find a solution to this?

Hi gerry, Thanks for the reply. Apologies that i havent explained very well. I havent shielded the sensors - only grounded. I havent got a shielding wire for the pressure sensor reading cable, and have only used a 0.22mm wire. The values i am getting are jumping around a little bit, which i assume i...

bump

Hi All,

I am looking for some advice with PICOLog on the Pi 4. I have connected to official 7" screen but the PicoLog window is far too big. Is there a fix / solution someone might be able to assist with?

Thanks all!

Good afternoon all, I am looking for some advice. I have bought a PICOLog 1216 to capture 8 pressure sensors at the same time. I have built a box and mounted all inside the box using terminal blocks to split 24v supply to each sensor and ground. The sensors have a shielding but to connect between th...