I’m trying to supply a range of 0-5V through a pressure transducer to my ADC-20 board. I was hoping there was a way to systematically reduce the output of the pressure transducer by 2.5V to make sure the board is in the acceptable -2.5V to 2.5V range. Possibly by hooking up the output of my transduc...

When we press the enter key or wobble the USB picolog wire the results we're getting from our pressure transducer shift a lot. Is there anything we can do about this? Also when the transducer is left still the picolog reading shifts gently downwards in voltage reading over time. I was wondering if t...

Yes our setup is Pin 2 of the transducer connected to both AG on the board and the ground of your supply, and Pin 3 connected to Channel 1.
We are using Picolog 6 (v1.5) software, the results we're getting are as expected but of the opposite sign (negative voltage rather than positive!)
Thanks

Have connected a pressure transducer and this time the output is negative not positive, the setup is detailed in the pictures below.

Any advice would be brilliant.