sorry forgot to answer your questions. No they are directly connected and they are using our own software. A reboot of the PC doesn't reset them so I guess there are continually powered throughout the reboot.

Regards.

OK Thanks Hitesh.

Will the new ps4000.dll give any other options in the future?

Regards,
Patrick

I should add that the scopes are PicoScope 4226 devices. and controller version is 1.13.4.0

Thanks

Hi, We have a system with 3 scopes installed in a remote location that we use with our own software. Problem is that the PC was rebooted when they were waiting for a trigger event that never arrives. On reboot only 1 of the 3 scopes can now be correctly initialised. 1 hangs the process and the other...

Hi, I´m getting a lower data rate than expected in my own code using the GetValues call on a pico 4227. status = ps4000GetValues(unit.handle, 0, (unsigned long*) &sampleCount, 0, RATIO_MODE_NONE, 0, &overflow); This call is taking approx 3.8 secs to return 12500000 samples (from both channels so 400...

Hi,

Thanks for that. Seems to trigger ok for me now.

But not sure why you put FALLING as the trigger direction and pulse width direction of RISING_LOWER. Are these because I said it was a positive pulse? What about the POSITIVE_RUNT value?

Regards,

Patrick

Hello, I'm having a problem coding up a pulse width trigger and can't find an example of one in the sdk. Just wondering if you could check the code snippet below or point me to an example. Basically I want to code up chan A, positive pulse, threshold of 100mv and pulse width less than 100ns and 1.5%...

Hi, I think I have the same problem here. I´m trying to get the difference in trigger times between samples collected in rapid block mode. Is there a way to do this? I have tried both of the following but they appear to be as you say the offset from each trigger event rather than an absolute trigger...

Hi, Just wondering if you have date for when the 4226 SDK will be available. I just tried using the 4224 SDK with it but the get_info(&unit) call doesn't appear to return valid info.

Regards,

Pat