As recommended by NI, I installed the latest Version of LabVIEW NXG 1.0 for development. I tried to migrate the LabVIEW Project in LabVIEW NXG. I found,It is easier to operate the installed NI Hardware. And the Panel Looks nicer. However I have Problem of PicoScope example code conversion: there are...
Do you mean the .csv file? I defined 1024 Points in PicoScope6. I posted it in previous post.
I also tried the Signal with less Resolution to 128 Points.
The LabVIEW generated waveform is always not correct.
thank you for your indication.
I would like to generate the Signal with 25Hz frequency. I changed the Parameter in the LabVIEW Panel. The generated Signal remains unchanged. Have I done right?
PicoScope6 generated Signal is waht I expect.
However the Signal generated using LabVIEW example"PicoScope3000aExampleAWG.vi" (second screenshot) has distortion.
Can I improve the LabVIEW example to generate the same Signal as PicoScope6 does?
Signal generated by .csv file using Software Picoscope6 is as defined.
In the .csv file, 1024 Points are defined. Could the sample rate of LabVIEW example the root cause? How can it been changed?
PicoScope 3203D is under test.
Applying the same arbitrary defined Signal via .csv file, the measured Signal generated from the LabVIEW example (PicoScope3000aExampleAWG.vi) has obvious distortion.
While the measured Signal generated from Software PicoScope is OK.
Have you also noticed this?
Thank you very much for the link of the .llb file. With this .llb, the previous vi works! After Evaluation of the .vi with the function combination of BlockMSO and Signal Genrator, I found it not satisfactory: it does not have the full function of both single .vi. Optimized .vi examples for would be...
I downloaded the LabVIEW examples with .dll from GitHub repository.
They have the same error message as previous: missing "PicoScopeVolts'ToAdc.vi". While the examples with .dll from your Homepage are OK.
The PicoScope300aSettings.vi differs from the one in picoScope300a.llb from SDK. Where the PicoScopeVoltsToAdc.vi can not been found.
Is the picoScope300a.llb on development?
Hello Hitesh, thank you for your advice. The Situation is, each single function (.vi) works well, But by modification of these SDK examples, Errors of data type mismatch occurs. Could you please tell me, if there are already successfull use cases to apply PicoScope's functionality of Scope+signal Ge...
The .vi examples with single function like Streaming mode capture and AWG from installed SDK work well. I want to integrate single .vi(s) with single function like Streaming mode capture and AWG into ONE .vi. Sothat I can apply the LabVIEW driven PicoScope for DAQ to the bigger Project with other La...