Yes, the power supply is connected to the scope. PS6 seems to accept it, because without the supply I get a message that only two channels will be supported when bus-powered. I use an USB 3.0 hub with its own power supply. All the other devices at this hub keep working fine (mouse, keyboard, Peak US...

Hey guys. I have a.. PicoScope® 6 - PC Oscilloscope software version: 6.13.15.4081 Model: PicoScope 3406D MSO USB Version: 3,0 Calibration Date: Donnerstag, 6. Oktober 2016 Hardware Version: 1 Driver Version: 2.1.9.934 Firmware Version: 1.7.5.0 / 1.0.66.0 and a weird issue. If I start the software, ...

Hey everyone, I just encountered a weird issue on my 3406D MSO. I am measuring an SPI with 4MHz, software version 6.13.15.4081. A CS B clock C MOSI D MISO Trigger is set for rising edge on channel B, trigger works. I set the scale to 500µs/div and 1GS, all channels at +/- 5V. I capture a waveform (t...

Hey there, I am thinking about buying a 3205D MSO, maybe even the four channel version. In the future it is very likely, that I have to decode OABR (also called BroadR-Reach), which is essentially 100MBit/s Ethernet with a different physical layer. 100BaseT uses two pairs for communication, OABR use...

Hi everyone. I am trying to read a 10MBit/s Flexray with my new 5444B. I attached two probes to the bus lines, and ground. The sample rate is set to 500MS/s and 8 bit hardware resolution. I can see the frames, there's a bit of noise but the signal is clearly distinguishable. Serial decoding is set t...