Picoscope software is good at allowing you to startup using saved startup settings but I am used to a scope turning on with settings the same as when I turned it off.

Is there an option of making Picoscope behaving the same way? I don't see any option in preferences.

Thanks

Hi, I have just been looking at some I2C signals. I have a write followed 1.5ms later by a read. If the write fills the whole screen then the read is missed. If I slow down the time base, I can see both the write and the read and the I2C gets decoded correctly. My question is: Can I workout the rear...

Sorry, I found it:

Click on VIEW -> display format in the Serial Decoding window and take your pick.

Impressive

RS232/UART decoding is an awesome feature.

I can't see a way to change the data from Hex to ASCII.

Am I correct in assuming it is a feature yet to be implemented?

Thanks

Hi, I was running my PC with two monitors. Somehow the second monitor drive has died and Picoscope opens off screen. Where the second monitor used to be. I am using Windows XP. I no longer have the desktop expanded to two screens. I have tried uninstalling Picoscope software and reinstalling it. Any...

Hi,
I'm puzzled by step 4 of Section 4.2.4.2 (page 11) of the 3000 series User Guide.

It says: Using ps3000_get_timebase() select timebases until the required ns per sample is located.

I thought I could just work out the settings and use the ps3000_run_block call.

Thanks

Hi,

I have picoscope software version 6.0.12.2

I have set all my scope probes up as X10 probes but the trigger level down the bottom doesn't correspond to the trigger level shown by the trigger reference point diamond. Is this a bug?