I am a new user of the picoscope 3206A. I have been trying to write a program that triggers the scope to start recording data from a circuit.
Would please assist in this regard.
Hi, Thanks for for replying. I"m actually trying to measure the power consumption of an Atmega168 microcontroller as it perfoms some computations, so i'm meaasuring through channel A on the ground line of the power supply of the microcontroller. I'm expecting the oscilloscope to be riggered as soon ...
Im finaly geting some data from the oscilloscope, however I'm struggling with the triggering of the scope.
I'm sending a sinusoudal signal to channel A of the oscilloscope, my trigger setting seem not to be working.
I have attached a picture of the measurement. Would you please assist.
Hi, Thanks for the advice. it seems that the scope is measuring something for the circuirt. but i'm struggling to trigger the scope to measure the voltage drop, when the micontroller start to executer some AES code, as i'm recieving a lot of noise. So i suspect that if I can remove the noise then I'...
hi, I'm trying to measure the power consumption of the microcontroller while it is performing some operaions and i'm taking the power consumption signal measurements by inserting a shunt resistor(1ohms) between the ground line of the power supply of the microcontroller. So at the moment I'm not gett...
hi, I just bought a picoscope3206A, but now im faced with a problem of taking measurements. When I test if the probe is working by puting my finger on it, it show a noise signal on the software. When I try to take actual measurements (an output signal from an atmega168 microcontroller) from a circui...
Hi,
I am using c language. is it possible to use the trigger settings on the pico software to successfully trigger the scope to capture the power measurements of an atmega168 controller while it is in operation?