Search found 4 matches

by tack1000
Mon Jan 23, 2006 3:01 pm
Forum: PicoLog
Topic: Multi Converters
Replies: 3
Views: 4041

Hi

So from your reply ONE rate does all, not quite sure what you meant by last comment. Please a little more basic for a thickky.

Tack1000
by tack1000
Mon Jan 23, 2006 2:50 pm
Forum: PicoLog
Topic: Multi Converters
Replies: 3
Views: 4041

Multi Converters

Hi I am wanting to use the TC-08 (USB type) and the ADC 11 (serial port type) at the same time and would like to know if the sampling rate for the ADC 11 has to be the same as the TC-08? The TC-08 is full (all ports used) with a sampling rate of 800 MS. Where as the required rate on the ADC-11 would...
by tack1000
Tue Mar 15, 2005 1:47 pm
Forum:
Topic: How to connect ADC 11 to 2 source of waveform?
Replies: 4
Views: 6118

Hi Sarah I was under the impression that the volt range was 0 to 2.5 volts......... Product ADC-11/10 ADC-11/12 ADC-22 Resolution 10 bits 12 bits 10 bits Number of input channels 11 11 22 Input voltage range 0 - 2.5 V Typical sampling rate(measured on 100MHz Pentium) 10kS/s (10,000 samples per secon...
by tack1000
Tue Mar 15, 2005 11:58 am
Forum: Getting Started
Topic: New user best set up
Replies: 1
Views: 3264

New user best set up

Hi I would like to use pico ADC-11 to measure the decelleration of a large rotor. The decelleration would take place within two 1/8 portions equally spaced about of a full rotation, then it would try to return to its original speed by means of a diesal engine. This rotor is spining at 1950 RPM. I am...