This might be down to character sets. In testing, I found that the 'mu' symbol is fine when displayed in the Command Prompt window but not when exporting to file.
Our Development Team are looking at measurements so I will report this.
With regards to the Automation Commands, please refer to this post.
Additionally, use ? at end of an option to find out about the item and for outputs
Thanks Hitesh,
So I'm using a batch file, hitting Enter when I want to record data.
In a DOS box At CMD prompt, I type the Measurements command and I get only one line back - GOOD!
But when that same command is in the batch file with text result >> sent to file, it breaks into multiple lines.
The number of lines may vary after reboot - BAD!
Of course I then want to parse this text file to input to Excel, it is not proper CSV, and the units vary uV (aeV), mV and nothing for V. All that very much complicates conversion.
While I'm on it: It's frustrating to have to always reset the LP filter settings on restart.
I'd really like to have the Excel com control but had no luck with several flavors.
thanks for the samples, you posted.
In a batch, it is working fine. But i need, 4 chanels reading.
Is there a option, where I can define which channel?
At the moment, i get only chanel D Values.
I Use 5442A with PicoScope6 Win7 enterprise.