ADC-11 with PCMCIA adapter

Post any questions about our parallel port products
Post Reply
dbrennan
User
User
Posts: 2
Joined: Tue Jan 16, 2007 2:09 am

ADC-11 with PCMCIA adapter

Post by dbrennan »

I have used the ADC-11 with a laptops running Windows 2000 and a Quatech SPP-100 PCMCIA to Parallel port adapter with no problems. I have tried several times to run this same configuration with Windows XP and can not make it work. The error is the same cannot find pico.sys V4.3. Do you have any ideas?

Sarah

Post by Sarah »

Hi

Thank you for your post.

What does the error say exactly? Is it that the sys file isn't found or that the sys file cannot find the unit? Which software is giving the error?

What mode is the parallel port set to? Is this something you can change?

Let me know how you get on.

Best Regards

dbrennan
User
User
Posts: 2
Joined: Tue Jan 16, 2007 2:09 am

Post by dbrennan »

I am currently using PicoLog for Windows Version 5.14.6 but I have used Version 5.04.7 for a few of years. When I switch to Windows XP and got the error I up graded my PicoLog S/W to the latest version on your web site.
The error occurs during set up of the logger under converter details, when I select ADC-11 (Parallel Port) and Port LPT1 and click OK the Device status dialog box appears with the following:
ADC11/22 Driver V4.3
pico.sys not found

I am not sure of the mode selection details but I do have the adapter set up as LPT1, use no interrupts, and legacy plug & play enabled with the latest drivers installed from the adapter manufacturer.

ziko
Advanced User
Advanced User
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots

Post by ziko »

Hi and thank you for your post.

I would recommend downloading our latest software. I would also remove the old software completely before re-installing the new one. Let me know how you get on.

Kind regards
Ziko

Technical Specialist

hibik1
Newbie
Posts: 0
Joined: Mon Sep 13, 2010 5:26 pm

Re: ADC-11 with PCMCIA adapter

Post by hibik1 »

Hi,
I am currently experiencing the same problem as Ziko, my OS is windows XP. At startup, the voltage signal is always zero and when i try to change the converter, an error pops up saying

ADC11/22 Driver V4.3
pico.sys not found

I have already tried uninstalling and installing the laster driver. Still the same result. In the past month, the equipment was working well till last week when somedays it was okay, somedays it showed the error above. Recently, the error have been more frequent.

Pls advice. Thanks

ziko
Advanced User
Advanced User
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots

Re: ADC-11 with PCMCIA adapter

Post by ziko »

I would uninstall the software version you have right now and install either the latest version or 5.16.2. What version are you currently using?
Ziko

Technical Specialist

Post Reply