PicoScope 7 Software
Available on Windows, Mac and Linux
DC voltage issue
DC voltage issue
On my PicoScope 6, when I set up the AWG to output a DC voltage at 2V, the scope shows it's 200mV, not 2V. This is regardless of the position of the attenuator slide on the probe (X10 or X1). I checked the AWG output with a meter and it is in fact, 2V. What gives?
Re: DC voltage issue
When the slide on the probe makes no difference then it is broken and stuck in the x10 mode.
When you go to the property's of chanal A then you can set that you have a x10 probe and the measurements will be correct.
I also suggest replace the defective probe.
Regards,
Benno
When you go to the property's of chanal A then you can set that you have a x10 probe and the measurements will be correct.
I also suggest replace the defective probe.
Regards,
Benno