logging of temperature measurement with ADC-16

jeffspedding · Post by **jeffspedding** » Tue Jan 03, 2006 1:57 pm

We are now very successfully using an ADC-16 (plus laptop) using 3 channels with terminal connection board for on-line measurement and display of 3 separate parameters (2 are in range approx. -100 to +400 mV, 1 is a 4-20 mA with 120 ohm shunt).

We want to add a 4th channel to measure/display temperature in range of say 10 - 100Â°C. Do you sell a suitable module with temperature sensor? You refer to a LM35DZ IC in the ADC-16 terminal board booklet. Where can I buy such.

Thanks for your help. The ADC-16 system is doing a great job up to now.

Jeff Spedding

Michael · Post by **Michael** » Wed Jan 04, 2006 1:42 pm

Hello Jeff,

Glad to hear of your success.

We do not supply the device mentioned in our documentation but it is available from many electronic component suppliers.

Please try one of the following:
www.rs-components.com
www.farnell.com

You should find this component quite easily.

Best regards,
Michael