Hello, I've update picoscope SW release 6.10.18.1052, but now I'm unable to detect my PICO : unable to find it? My PICO doesn't appear when I refresh device list....
It would also be helpful to send in the trace.xml file corresponding to the last session with the PicoScope 6 Beta software (see section 3 of the guide).
Hopefully this has been translated correctly - the message appears to show that there is a peak power on the USB port hub. Are you using a powered USB hub at all?
Did the PicoScope work prior to the software update and did you try PicoScope 6.11 Beta?
Are you connecting the device via a USB 3.0 port or using the dual-headed USB 2.0 cable on USB 2.0 ports?
In the Windows Device Manager, does the PicoScope appear as an 'Unknown Device'.
When and where did you purchase the PicoScope 3206DMSO from?
PicoScope is connected direct to my PC (no Hub), i've tried on different USB port direct on PC, always same trouble.
I'm using one USB 3.0
PicoScope doesn't appear in the device manager
He work, but last time, at the startup message appear, I clear and restart PC and it's work. But now, unable to start, always the same msg, even on a PC where I dont' use picoscope (SW not installed, windows must recognize and ask to install driver, but not error msg only).
I've purchased Picosope throught Radiospares, less than one year ago (warranty for few days)
Is there no risk with Beta release?
Dual headed with two USB2.0 was delivered with pico, if yes I can try it?
Is phone call possible?
The Beta release normally contains new features which have not been fully tested but should then become stable once it has been through the testing process here.
If you have the USB 2.0 cable please try it as well.
You can call us via our Skype ID pico_tech_support or via the telephone number on the About Pico Technology page on our website.