Pt104 no temp reading

Post any questions about our serial port products
Post Reply
joe

Pt104 no temp reading

Post by joe »

Hi, using the pt104 with seven channels (2 units).
The pico recorder software "sees" the pico units as it gives a calibration date and some number after it when I hit "status".
I can not get temp readings after renaming the channels: "******* deg C"
Using the 4 wire option, I buzzed out the wires and the resistor. I simplified it down to one temp unit. Can't get it to read. Any help?
Oh, I've tried two versions of the SW.
Is there a "go" button I'm an missing or something? :?

Guest

Re: Pt104 no temp reading

Post by Guest »

To elaborate further: If I disconnect the units or the cables it give the error: can't open com port. That coupled with the status functionality makes me think I am actually seeing the pt104s.

Guest

Re: Pt104 no temp reading

Post by Guest »

Anonymous wrote:To elaborate further: If I disconnect the units or the cables it give the error: can't open com port. That coupled with the status functionality makes me think I am actually seeing the pt104s.
I used an old driver to fix it. Uninstall did not actually uninstall the software, so I had to manually erase, then reinstall. THANKS PICO

Post Reply