Picoscope5000 specification compare to IEC61083-1 standard

Post any questions you may have about our current range of oscilloscopes
Post Reply
ahmadtarmimi
Newbie
Posts: 0
Joined: Sun Mar 22, 2015 3:18 pm

Picoscope5000 specification compare to IEC61083-1 standard

Post by ahmadtarmimi »

Good Day,

I'm doing testing on high voltage testing or impulse voltage testing using a picoscope5000 series
requirement for the testing is to confirm hardware are complying with IEC61083-1 (hardware requirement for testing in HV for an impulse voltage)
The testing was done using voltage divider and attenuator since voltage range for picoscope +-20VAC/DC

I did some reference check with the IEC standard and Picoscope 5203 and 5244B datasheet but i found some requirement are not written down on the data sheet regarding the hardware

Can you advise for this matter

Attached is also my reference check


Best Regards
Tarmimi
Attachments
cross reference check.gif

Hitesh

Re: Picoscope5000 specification compare to IEC61083-1 standa

Post by Hitesh »

Hi Tarmimi,

Could you please e-mail this request to support@picotech.com and we will look to assist you further.

Regards,

Post Reply