"serial decoding is not supported for this sampling mode"

Forum for discussing PicoScope version 6 (non-automotive version)
Post Reply
stevenvh
Newbie
Posts: 0
Joined: Mon Feb 09, 2015 3:02 pm

"serial decoding is not supported for this sampling mode"

Post by stevenvh »

I'm using my 3200D MSO in digital mode, and want to decode the UART data on one of the channels. But PicoScope says
serial decoding is not supported for this sampling mode. Please change the mode and try again.
And indeed, the data shown is wrong. I would like to add more information about my settings, but I'm not sure what I should look for. What are required conditions for the decoder(s)?

Martyn
Site Admin
Site Admin
Posts: 4491
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Re: "serial decoding is not supported for this sampling mode

Post by Martyn »

If you send in the psdata file for this situation we can take a look at what is causing the message.
Martyn
Technical Support Manager

stevenvh
Newbie
Posts: 0
Joined: Mon Feb 09, 2015 3:02 pm

Re: "serial decoding is not supported for this sampling mode

Post by stevenvh »

It looks like I can't reproduce the error. For the moment the decoder does its job. I'll send you the .psdata file when/if it happens again.

Post Reply